Flexible Epoxy Gel Adhesive

OSVX523

DESCRIPTION:

Product #OSVX523 Flexible Gel Adhesive is a two component, 100% solids, mixed at a 1:1 ratio adhesive formulated to give a permanent bond to ceramic, metal, concrete, and elastomeric surfaces. Product #OSVX523 Flexible Gel Adhesive is thixotropic, non-sag, and is easily applied by trowel.

ADVANTAGES:

Excellent bond to most substrates.
Permanent flexibility, molecularly fixed, will not migrate.
100% solids, non-combustible.
Thixotropic
Light Gel
Dependable gap filling adhesive for permanent adhesion of structural components.
Convenient one to one by volume mix ratio.
Excellent chemical resistance.
Excellent recovery from deformation by compression or elongation.
Stays flexible at temperatures as low as -20° F (-29° C).
Retains properties at temperatures as high as 300° F (149° C) in intermittent exposure.
Can be used to stop leaks between ceramic insulators and transformer housing.
Can be used at temperatures as low as 40° F. and rising
Bonds PVC for non-structural applications.

PHYSICAL PROPERTIES:

Color	Light Gray
Mix Ratio	1A:1B by volume
Viscosity	Light Gel
Gel Time (min.)	10 minutes @ 75° F (23° C)
Compressive Strength ASTM C-579, Method B	3,000 psi min. - 7 days
Tensile Strength ASTM D-638	1,350 psi min. - 7 days
Tensile Elongation (min.) ASTM D-638	50% - 7 days
Lap Shear - Steel to Steel ASTM D-1002	800 psi min. - 7 days

SURFACE PREPARATION:

Surface must be clean. Remove grease, rust, or other foreign materials by best means available. For best results surfaces should be dry during application.

MIXING:

Combine one part by volume of Component "A" with one part by volume of Component "B". Mix for not less than (3) three minutes using a slow speed drill (300 to 600 rpm) and Epoxy.com-Mixing Paddle.

SHELF LIFE:

1 year

CAUTION:

WARNING! "A" Component contains epoxy resin. DANGER! "B" Component contains alkaline amines; strong sensitizer. May cause skin sensitization or other allergic responses. Use with good ventilation, particularly if material is heated or sprayed. Prevent all contact with skin or eyes. Wear protective clothing, goggles, gloves, and/or barrier creams. Keep containers closed when not in use. Wash thoroughly after handling.

FIRST AID:

In case of skin contact, immediately wash with soap and water. In case of eye contact, flush with copious amounts of water for at least (15) fifteen minutes. Remove contaminated clothing. If irritation persists, seem medical attention. Wash clothing before reuse.

FOR INDUSTRIAL USE ONLY. KEEP AWAY FROM CHILDREN.