Epoxy.com Logo - Epoxy, Polyurethane, Polysulfide, Polyester, MMA - Methyl Methacrylate and other Construction Resin Systems - Over 350 Products- Since 1980
[Contact Us]

Epoxy.com Product #675

Electro-Static Dissipative Water Emulsion Finish


Epoxy.com PRODUCT #675 is a pigmented, water emulsion epoxy electro-static dissipative finish designed to have maximum penetration into concrete surfaces to provide high bond strength and adhesion. Epoxy.com PRODUCT #675 has very low odor and can be used in occupied areas as a finish sealer in Thin-Film Electro-Static Dissipative Coating Systems.


  • Low Odor During Application and Cure
  • Fast Dry and Re-coat Time
  • Easy Clean-up
  • Can be used on Damp/Green Concrete
  • Greatly Reduces the Probability of Concrete Outgassing
  • Provides a conductive finish in the range of 1,000,000 to 1,000,000,000 ohms resistance


  • Substrate temperature must be a minimum of 50?F and relative humidity below 85% for proper curing
  • Substrate must be free of dirt, waxes, curing agents, and other foreign materials


Waterborne Epoxy Resin and Conductive Fillers



Surface Preparation is the most critical portion of any successful resinous flooring system application. All substrates must be properly prepared as outlined in Epoxy.com TECHNICAL BULLETINS. Work must be performed by trained or experienced contractors or maintenance personnel. Epoxy.com Technical Service department is pleased to answer any questions.


Mix each component of Epoxy.com PRODUCT #675 prior to combining. Mix 1 part Part A with 4 parts Part B and allow to stand 15-30 minutes before applying. Roll mixed Epoxy.com PRODUCT #675 at a rate of 275-300 ft2 per gallon with a short nap roller. Care should be taken to avoid puddles. Do not build a film of the sealer and roll out so that it soaks into the concrete. Two coats are necessary to insure uniform wetting and coverage. For complete installation instructions, contact Epoxy.com Technical Service.


Clean skin with soap and water. Tools and equipment should be cleaned with xylene or lacquer thinner. Consult Material Safety Data for safety and health precautions.


Epoxy.com PRODUCT #675 is available in most Epoxy.com Standard Colors.


Epoxy.com PRODUCT #675, when applied at 300 ft2, yields 2-2.5 mils dry film.


Viscosity @ 75°F 300-400 cps
Mixing Ratio 1 Part A to 4 Parts B by Volume
Solids Content 40-45%
Volatile Organic Content (VOC) <60 gm/L
Bond Strength to Concrete 400-500 psi (100% concrete failure)
Weight per Gallon 8.75-9.00 pounds per gallon, mixed


Pot Life 2-4 hours
Dry to Touch 4-6 hours @ 75°F
Re-Coat 6-24 hours @ 75°F
Light Traffic 24 hours @ 75°F
"H" Hardness 2 days
"5-H" Hardness 30 days


If floors become slippery due to animal fats, oil, grease, or soap film, clean and rinse thoroughly.

Epoxy.com PRODUCT #675 is easily cleaned with neutral soaps or detergents. Routine mechanical scrubbing is recommended for all surfaces having a non-skid texture. Waxing is optional. Long periods of heavy traffic may cause wear patterns necessitating a maintenance application of a finish coat.

Proper mixing and installation is critical to the optimal success of all products.  See Installation Tips, Techdata, & MSDS for more details on our products.  Be sure to contact us with any questions and/or concerns that you have.

For more information please contact:

A Division of Epoxy Systems, Inc
A Vermont Corporation

We have products that have passed the test of time as well as the best new Systems available today.

Since 1980 - 40 years of the highest quality products

Hours: 9AM-4PM Eastern Time (6AM-1PM Pacific Time)

Closed for lunch from 12Noon to 1PM

321-206-1833  Customer Service - Ordering and Order Status
                         Katey Lambert-Fontaine, VP - Chief Operations Officer

                        Technical Support
352-533-2167  Norm Lambert, President - Technical Support Director 

352-489-1666  Accounting and Administration
                         Debby Lambert, CEO, and CFO

Copyright © 1994-2023 (providing online information about the right product for the right job for nearly 30 years)  EPOXY.COM a division of Epoxy Systems, Inc. - Florida and Vermont.  All rights reserved.

We accept MasterCard, Visa, American Express, Discover, Wire Transfers, and Cashiers Checks
We accept MasterCard, Visa, American Express, Discover, or Wire Transfers.