More Product #2 Information
ADVANTAGE
MIXING INSTRUCTIONS
Temperature of Product #2 must be 50 degrees F or above at time of mixing. Stir each component separately before blending. Mix two parts by volume of Part A with one part by volume of Part B for three minutes with a low speed electric drill motor equipped with a mixing paddle.
APPLICATION
Apply Product #2 with a roller, brush, or spray equipment. Two coats are recommended. Thickness per coat should be 7-10 mils. Seven days cure time is required to reach maximum chemical resistance.
LIMITATIONS
Refer to Product #2 Chemical Resistance Chart for field tested results of common industrial chemicals that Product #2 has been exposed to. New concrete should be at least 28 days old. Temperature of substrate must be above 50 degrees F. DO NOT thin.
SAFETY PRECAUTIONS
Prolonged or repeated exposure may cause eye and skin irritation. If contact occurs, wash immediately and seek medical help. Use safety glasses with side shields and wear protective rubber gloves.
CLEANING
All tools and equipment should be cleaned before the system gels. Use MEK, Acetone, or any lacquer solvent.